neoOBD 2 DEV

Device Specifications

• Device boot up in 1.2 seconds
• Low power consumption
• Power supply: 3.55-36V operation with transient to 42V
• Four full-color status LEDs
• Temperature range: -40°C to +85°C
• Vehicle connectors: 16-pin OBD 2 male
• One-year limited warranty
• Field-upgradeable flash firmware
• Microsoft-certified USB drivers
• USB Type-C Host for neoVI MIC GPS or powering accessories like a Raspberry PI drawing up to 3A at 5V
• High speed (480 Mbits/sec) USB interface
• Standalone mode support, including scripting, receive messages, transmit messages, expressions, I/O and transport layers
• J2534 and RP1210 A/B compatible for CAN/ISO15765-2:2016 (CAN FD)
• 32GB eMMC Storage
• Battery-backed real time clock (RTC)

Timing Specifications

• 64-bit timestamping to an accuracy of 25 nanoseconds on CAN FD networks and 10 microseconds on LIN networks with no overflow
• Accuracy of 0.5 microseconds possible if using only one network
• Simultaneous operation on all CAN/LIN networks
• Transmit message double-buffering on all networks, allowing back-to-back message transmission

Network Specifications – CAN

• 4x ISO CAN FD channels implemented using the industry standard Bosch MCAN CAN FD core
• CAN 2.0B compatible for all CAN networks
•  Up to 4x ISO CAN FD channels implemented using the industry standard Bosch MCAN CAN FD core
• CAN 2.0B compatible for all CAN networks
• Up to 4 dedicated ISO11898 Dual Wire CAN FD physical layers (MCP2562FD)
• 1 dedicated Single Wire CAN physical layer GMW3089 / SAEJ2411 (MC33897) – Optional
• Up to 1 Mb/s software-selectable baud rate for arbitration phase (auto baud capable)
• Up to 8 Mb/s software-selectable baud rate for data phase (auto baud capable)
• Listen-only mode support
• Single Wire High Speed Mode, Test Tool Resistor, and High Voltage Wakeup support

Network Specifications – LIN, ISO9141, Keyword 2000 or K and L Line

• 1x LIN (Local Interconnect Network)
• Full support for LIN 1.X, 2.X and J2602
• LIN J2602 / 2.X compatible physical layer
• Software-enabled 1K LIN Master Resistor per channel
• LIN Bus Monitor Mode identifies errors: Sync Break Error State and Length, Sync Wave Error, Message ID parity, TFrameMax/Slave Not Responding, Checksum Error and Transmit Bit Errors
• LIN Bus Master Mode operates at same time as LIN Bus Monitor
• LIN Bus Slave simulation, with or without an LDF file
• LIN Bus hardware schedule table with support for LIN diagnostics
• Initialization Waveforms, including Fast Init, Five Baud, and Custom
• Software-selectable baud rate

Network Specifications – DoIP / XCP / Automotive Ethernet

• 10/100 Ethernet PHY with low-power mode
• Compatible with 100BASE-T1 / BroadR-Reach® using Intrepid RAD-Moon media converter accessory
• Software-controlled DoIP activation line

* Specifications subject to change. Please contact Intrepid for the latest information.